Purchasing Emergency Plumbing Situation

Your water heater is one that is used and more expensive appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and energy costs.

Regular flushing of your water heater is considered the single most important step you consider to prolong its service life and even save energy. For time, sediments build up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regions of the country, the standard water heater lasts 3-5 years. Regularly flushing your water heater can double daily life of your hot water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is a must in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.

To drain your water heater, initially you should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located in the water inlet line going into your water heater. You may then connect a hose to the drain valve located at the base of the heater tank. Open the drain and allow it working out until all of the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until the flows out gradually. This will allow air to vent from the heater and the water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas possess hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in place to discuss options and products to fit the bill.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Bookmark the permalink.